I finished my new Okto, updated all the boards, loaded and sent the octo2 configuration file but I have this error:

Requesting status information from Flight-Ctrl...
Version 0.86d
Errorcodes: 0x00 0x0A 0x00 0x00 0x00

- BL-Ctrl missing (check connections & mixer setup)
- no receiver signal

At startup every motor makes a round and sound.

The console shows infinites lines of code, never stops

No BL is found, every with error 127, the distribution boards came soldered from factory.

When I updated the FC it took 3-4 tries because had CRC errors at different % of flashing.

Removed navi and GPS but had the same result

Thank you

post some fotos of your soldering wiring.

that doesnt sound good.

http://imageshack.us/g/849/img1222gx.jpg/

I have checked for continuity C and D from every esc to the molex of the FC, and no short at others points

this is my first Mk so I can forget something but don't know, jumper on the esc are ok

Motor assignments, MKTool mixer setup (ALT-FlightSettings)...

After the wake and wiggle on power up, do you see just a green LED on that faulty BLctrl? If the red LED flashes, count the number--it's an error code.

BL n.5 has GREEN led fixed ON and RED flashing 3 times!

all others BLs RED+GREEN fixed ON

Didn't noticed, thank you

ALT-Flightsettings I can't find? I have Mikrokopter Settings (Flight-Control parameters) as you see in the pic I posted before

Thank you

Ok I found the first 5 legs of the chip shorted, I tryed to clean with a thin screwdriver but no luck, I think I need a new one.

http://imageshack.us/photo/my-images/718/immagine005yb.jpg/

Thank you

It blinks nomore but same error

I connected the FC alone directly to the MKUSB and I get that strange string, is it normal?
externer Link:

Nice flying time 59135 min.

It might just be a bad dist.board. I and many others have recieved faulty boards. The quality is not as it was before =(

I removed the BL n.5, connected to the MK Tool gives no errors

And the BLs has firmware 0.31b but the latest in the download section is 0.31a

jonteman meinte

It might just be a bad dist.board. I and many others have recieved faulty boards. The quality is not as it was before =(

What's the errors you had?

Thank you

NEW:

Now the MK Tool see correctly others BL, only error is n.5

motors 1,2,3,4,6,7,8 runs in motor test

Changed BL n.5 now the Octo is ready to fly!!!!!

p.s.

krleas meinte

Nice flying time 59135 min.

This is not fixed flashing the firmware? what's that?