MikroKopter - Forum » Photo & Video » SONY HDR-CX330e and LANC-Ctrl V1.1 + Multi adapter

SONY HDR-CX330e and LANC-Ctrl V1.1 + Multi adapter

Neues Thema Antwort

Seite: 1

Autor Neuer Beitrag
Mitglied
Registriert seit: Feb 2015
Beiträge: 5
Ort: Bulgaria
Hello everyone.
I bought a Sony camcorder model: SONY HDR-CX330e
http://www.sony.bg/electronics/handycam-videokameri/hdr-cx330e

(I looked at the store before I bought and I was convinced that there are multi-port)
I bought LANC controller of mikrokopter: Sony LANC-Ctrl V1.1 + Multi adapter
http://www.mikrokopter.de/en/home

LANC turned to the camera and to the receiver, but the system does not work!
I tested LANC controller with another camera ( SONY DCR-HC42E ) and works perfectly!
http://www.sony.bg/support/bg/product/dcr-hc42e

Without supply of the LANC, video signal goes to the monitor - test with SONY DCR-HC42E
Without supply of the LANC, no video signal - test with hdr-cx330e
Tested camera multi port - turned it to a computer and work - can copy files from a camera.

Is it possible Sony hdr-cx330e no video out on multi port ?
Is it possible Sony hdr-cx330e no LANC port control on multi port ?
is there a way to manage this remote camera?

Please excuse the bad translation, but use google translator.
If the topic is written in the wrong section, please admin to move in the right place
« Bearbeitet von sm3hurk0 am 07.02.2015 22:33. »
Mitglied
Registriert seit: Feb 2015
Beiträge: 5
Ort: Bulgaria
Following a test until it is established that there is a problem in Multi adapter cable.
No transmission of signals in the cord. this may be due to a cold solder or use of the wrong PIN. When test cable ( MULTIPORT to AV out Handycam A/V Cable - VMC-15MR2 ) - all is OK. has video and 2 ch. audio.
Within a few days and will test LANC port. Tests are slow, but have full support of service Sony-Bulgaria
Possible problem may be a resistor that activates the video output & LANC of Multiporton camera.
Value recommended is 100к, but the activation using multiport recommend 180к.
This can mislead me and I think the problem is in multiport cable
« Bearbeitet von sm3hurk0 am 11.02.2015 00:26. »
Entwickler, Admin
Registriert seit: Feb 2006
Beiträge: 3790
Ort: Ostfriesland
IMHO hdr-cx330e has no LANC on multi port
Mitglied
Registriert seit: Feb 2015
Beiträge: 5
Ort: Bulgaria
I found a schematic diagram of SONY HDR-CX330e:
http://91263.bg/editor/ufo/files/Sony_MULTI.pdf

and ordered multiport connector:
from: http://mobilexcopter.com/shop.htm#!/~/product/id=39708561
Picture:http://91263.bg/editor/ufo/files/Sony_MULTI.jpg

Schemes shows that there LANC port

Camera is in service to a few days there will be a final answer
Schemes and image upload them on my website,
to make sure that it will always be available to consumers
« Bearbeitet von sm3hurk0 am 17.02.2015 13:58. »
Mitglied
Registriert seit: Feb 2015
Beiträge: 5
Ort: Bulgaria
"The 2014 camcorders from Sony still have the Multi-Port jack, however, Sony has made the VMC-AVM1 adapter cable incompatible with the 2014 camcorders and they have changed the LANC interface to a non-standard format. So they only remote that will work with the 2014 and 2015 camcorders is the RM-VPR1 from Sony. This has a very short cable length and can not be extended."
See link: http://www.studio1productions.com/lanc-sa.htm

full service documentation for: SONY HDR-CX330/CX330E/PJ330E/PJ340/PJ340E/PJ350/PJ350E
http://91263.bg/editor/ufo/files/hdr-cx330.pdf

SONY HDR-CX330 can not work with this adapter - LANC-Ctrl V1.1 + Multi adapter
reason: there is a difference from the standard LANC protocol !
« Bearbeitet von sm3hurk0 am 15.03.2015 23:40. »
Mitglied
Registriert seit: Feb 2011
Beiträge: 4583
Ort: D-15378 Hennickendorf
Hello,

You can use the remote controlled via the multi-port, I've solved on my A5000 and HX400V. This should work with the remote control and additional electronics...

http://forum.mikrokopter.de/topic-48019-1.html

at post #14 and 15 ;)

I think, this can go at your cam...

best regards,
Stephan Lukas
Mitglied
Registriert seit: Aug 2012
Beiträge: 466
Ort: Speyer
Zitat
and ordered multiport connector:
from: http://mobilexcopter.com/shop.htm#!/~/product/id=39708561
Picture:http://91263.bg/editor/ufo/files/Sony_MULTI.jpg


Today I've got these plugs ... Can You tell me at what pins to wire
- LANC
- FBAS
- Restistor (100kOhm?) for switching to FBAS out

Thanks!
Mitglied
Registriert seit: Aug 2012
Beiträge: 466
Ort: Speyer
Habe den Link gefunden:

http://forum.mikrokopter.de/topic-43481.html

Da ist die Pinbelegung aufgeführt ... werds ausprobieren ...

Neues Thema Antwort

Seite: 1

MikroKopter - Forum » Photo & Video » SONY HDR-CX330e and LANC-Ctrl V1.1 + Multi adapter