I have a Quadropter with FlightCtrl ME 2.5 and BL_Ctrl 2.1 Drivers and a Futaba 7C-2.4 GHz FASST RC control. The situation is that the FlightCtrl board is not reading the signal from the spectrum receiver that is connected to the Rx pin. Also, the receiver can only send the signals for yaw, pitch, roll and gas through one channel (each signal needs a channel) and well... I know what channel is sending each signal but I only can connect one channel to the Rx pin. I dont know if I have to get an extra hardware to make it work or maybe with some set up for my RC controller. I´ve been following the steps in the Mikrokopter Wiki and I haven´t found any information about it, just how to connect a Spectrum Receiver to the FligthCtrl board. I will appreciate any help.