MikroKopter - Forum » Electronics » ACC Z error 1:32 on Octo Coax X8 with V3 Board

ACC Z error 1:32 on Octo Coax X8 with V3 Board

Neues Thema Antwort

Seite: 1

Autor Neuer Beitrag
Mitglied
Registriert seit: Dec 2014
Beiträge: 38
i install my old FC 2.2 on my new octo with V3 board and i get this Error

i load mixer setup from Mk site OCTO-X8 - i dont have graphics on Kopter Tool ( X8 photo orientation )

and i stille get this 1:32 Error ACC Z - it says that FC mounted upside-down !

but it is installed correctly

anyone can help me with this ?
Mitglied
Registriert seit: Apr 2007
Beiträge: 2320
Ort: Hesel
Hi,

please give us a photo from the installed FC. Then we can take a look ;-)
Mitglied
Registriert seit: Dec 2014
Beiträge: 38
here is a foto
externer Link:
User image
Mitglied
Registriert seit: Apr 2007
Beiträge: 2320
Ort: Hesel
Ok,

it looks like an damaged acc-sensor. Pls send the FC to HiSystems. They should test it.

Walter
Mitglied
Registriert seit: Nov 2012
Beiträge: 239
Ort: Ankara
Did you solder ACC Sensor by yourself?
Mitglied
Registriert seit: Feb 2012
Beiträge: 1857
The ACC Sensor look mechanically damaged! Is there a Sink on the Housing?!

Connect your Copter to the Copter Tool, and look at the ACC-Z Values in the Virtual Display and Graph. Does the Graph properly show movements and impacts? The ACC Value has to be below 700. If Copter/FC leveled, the Value should be between 670 to 699. You can Check this at the "ACC - Sensor" Menu on Page 6 at the Virtual Display (Flight Control).

Neues Thema Antwort

Seite: 1

MikroKopter - Forum » Electronics » ACC Z error 1:32 on Octo Coax X8 with V3 Board