Hi,

I´m not sure what´s happening with my okto, with the roll servo connected the okto loses i2c signal, but if I disconnect the roll servo everything works normally.


Any idea?

Maybe the servo is dead or some shortcircuit is misleading the board?




I don´t understand it, everything was working toghether perfecty, but today when connecting there wasn´t i2c signal, after playing around I´ve found this incompatibility

It´s the servo, I´ve connected it to an external rx and it does the same, the rx works until I connect the servo, then it loses the signal.....


This really worry me.... If a servo fails in flight you lose the whole okto?

I´ve never had such a problem in almost 20 years of rc flying and around 6 of fpv flying, anyone has suffered anything similar?

Is possible to burn the servo with some parameter of the mk-tool?

I hadn´t flight the okto yet, when I first connect it everything worked but with the last check before the maiden I found this problem

I´m thinking about the number of servos (set it to 2), servo limits, or similar. I had been playing with them and it´s the only thing I can think about that could be the cause.....

It´s an Hyperion ds16-fcd digital, programmed via servocommand for 180º (almost)